Before you start
Test time & results
15-20 mins
Sample
Finger-prick blood
Get ready
Check your kit. Make sure it's within its expiry date and the sealed test pouch is intact.
Check the temperature. Let the kit reach room temperature (10–30°C) before testing.
Find a good spot. Choose a clean, flat surface with good lighting.
Have a timer ready. You can use the one below or your phone.
What's in your kit
- Test pad – the small test device that shows your resultx1
- Lancet – used to prick your fingerx1
- Alcohol pads – for cleaning your fingerx2
- Pipette – used to collect and transfer blood and test liquidx1
- Diluent (test liquid) – the liquid needed to run your testx1
- Waste bag – for used test materialsx1
- Instruction leaflet – the manufacturer's full instructionsx1
Do the test
-
Wash your hands
Wash your hands with warm water and soap, then dry them thoroughly. Warm hands can make it easier to collect blood.
-
Open the test pad
Remove the test pad from its sealed pouch and place it on a clean, flat surface. Use it as soon as possible and within 1 hour of opening.
-
Clean your finger
Use an alcohol pad to clean the side of your middle or ring fingertip. Let it dry.
-
Prick your finger
Remove the protective cap from the lancet and use it to prick the cleaned area. Gently squeeze your finger to form a drop of blood.
-
Add 3 drops of blood
Squeeze the pipette, place its tip into the blood and release to collect a sample.
Hold it vertically and add 3 drops of blood to the round sample well on the test pad.
-
Add 1 drop of diluent
Using the same pipette, collect the diluent (test liquid) and add 1 drop to the same sample well, immediately after adding the blood.
Important: Using more or less diluent or blood than instructed may affect your result.
Press start after step 6
Keep this page open. The timer stops if you switch apps, change tabs or your screen locks. You can also set a timer on your phone.
Time's up! Read your result now.
Do not read your result after 20 minutes. Results read after this time may be inaccurate.
Read your result
Look at the window on the test pad. C is the control line. T is the test line.
-
Negative
No syphilis antibodies detected
One line appears at C, with no line at T.
Your result is negative. No syphilis antibodies were detected.
-
Positive
Syphilis antibodies may have been detected
Two lines appear, one at C and one at T. Even a faint T line counts as positive.
This result needs further testing at a sexual health clinic. It may reflect a current or previous syphilis infection.
-
Invalid
Test didn't work
No line appears at C, even if a line appears at T.
You can't rely on this result. Contact us and we'll help.
Finish up
Place your used test materials in the waste bag and close it. Each test can only be used once.
What happens next
If your result is negative
Your test did not detect syphilis antibodies.
Syphilis can take time to show up on a test. If you may have been exposed in the last 12 weeks, you may need to test again 12 weeks after your last possible exposure.
If you have symptoms or a partner has syphilis, contact a sexual health clinic now.
If your result is positive
A positive result doesn't necessarily mean you currently have syphilis. Antibodies can remain in your blood even after successful treatment.
Contact a sexual health clinic as soon as possible for further testing. They'll confirm what your result means and whether you need treatment.
Syphilis can be treated with antibiotics. If you've had syphilis before, let the clinic know.
Avoid sexual contact until the clinic has assessed you and advised you on what to do next.